IMC Networks iMcV-T1/E1/J1 Manuel d'instructions Page 1

iMcV-T1/E1/J1 Repeater Operation Manual

10 Switch Settings for Switch S2 T1/E1 Selection S2-1: OFF T1 Mode Selected default S2-1: ON E1 Mode Selected Receive Equalizer Gain Limi

11 Switch Settings for Switch S3 Jitter Attenuator Select S3-1: ON Place Jitter Attenuator on RCV Side S3-1: OFF Place Jitter Attenuator on

12 Module LED Functions This section describes the LEDs and their functions. The Fiber port LED RM is the only LED that should be lit on the modules

13 Testing To test a media converter by itself, first make sure there is an appropriate fiber patch cable, then perform the following steps: 1. Connec

14 The iMcV-T1/E1/J1 Repeater can be configured to use the following loopback test modes: Local Fiber Loopback Mode This setting tests the path from t

15 Remote Fiber Loopback Mode To set the loopback testing mode to Remote Fiber Loopback Mode, perform the following: 1. Set the Local iMcV-T1/E1/J1 Re

16 Testing with Pseudorandom Bit Sequence (PRBS) To test the copper segment from the Remote module to the Customer Premises Equipment (CPE) by using P

17 Specifications Power Consumption (Typical) 0.550 Amp @ 5V Operating Temperature +32°F to +122° F (0°C to +50° C) Storage Temperature -4°F to +158°F

18 Fiber Optic Cleaning Guidelines Fiber Optic transmitters and receivers are extremely susceptible to contamination by particles of dirt or dust, whi

19 Safety Certifications UL/CUL: Listed to Safety of Information Technology Equipment, including Electrical Business Equipment. CE: The products des

ii FCC Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class A computing device, pursu

19772 Pauling • Foothill Ranch, CA 92610-2611 USA TEL: (949) 465-3000 • FAX: (949) 465-3020 www.imcnetworks.com © 2011 IMC Networks. All r

iii Table of Contents FCC Radio Frequency Interference Statement ...ii Warranty...

4 About the iMcV-T1/E1/J1 Repeater The iMcV-T1/E1/J1 Repeater chassis mounted media conversion module allows the end user to extend the distances betw

5 Configuration The iMcV-T1/E1/J1 Repeater module is factory-configured to use the following default features: T1/E1 Mode T1 Receive Equalizer Gain

6 NOTE The iMcV-T1/E1/J1 Repeater modules are delivered pre-configured for standard T1 operation in Passive mode. To enable remote management, the us

7 Unmanaged Modules Before installing the iMcV-T1/E1/J1 Repeater module into an unmanaged chassis, configure the module hardware-selectable features v

8 Receive LIU Termination (Line Termination) This option allows the user to set the receive termination. This is used to properly terminate cables in

9 Remote Management This option allows the user to enable Remote management on the module. The remote management feature is designed to work only on