IMC Networks 10/100 Mbps Switching McPC MediaLinX Manuel d'instructions

McPC 10/100 (ISA & PCI Versions) Operation Manual

7 LED Indicators (PCI Version) The McPC 10/100 features four diagnostic LEDs. The following are the LED functions on the twisted pair port:

8 ISA Version Installing the McPC 10/100 (ISA Version) Offering plug-and-play operation, the McPC 10/100 comes ready to install, utilizing power from

9 Configuring the McPC 10/100 (ISA Version) Before installing, configure McPC 10/100 for desired features using the DIP Switch located as shown below

10 Modes of Operation (ISA Version) The McPC 10/100 features three modes of operation: Auto Negotiation mode, Force-10 mode and Force-100 mode. Config

11 There is no Auto Negotiation in either of the Force modes. Auto Negotiation (ISA Version) When connecting two McPC 10/100s between two end stations

12 When the McPC 10/100 is in one of the Force modes, enable LFD by setting 5 to the ON position. Disable LFD by resetting 5 to its default, OFF, pos

13 LED Indicators (ISA Version) The McPC 10/100 features four diagnostic LEDs. The following are the LED functions on the twisted pair port:

14 Specifications (PCI and ISA Versions) Environmental Operating Temperature 32° - 104° F (0° - 40° C) Storage Temperature 0° - 160° F (-20° - 71° C)

15 Fiber Optic Cleaning Guidelines Fiber Optic transmitters and receivers are extremely susceptible to contamination by particles of dirt or dust, whi

16 Safety Certifications UL/CUL: Listed to Safety of Information Technology Equipment, including Electrical Business Equipment. CE: The produc

ii FCC Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B computing device, pursu

19772 Pauling • Foothill Ranch, CA 92610-2611 USA TEL: (949) 465-3000 • FAX: (949) 465-3020 www.imcnetworks.com © 2009 IMC Networks. All rig

iii Table of Contents FCC Radio Frequency Interference Statement ...ii Warranty...

1 About the McPC 10/100 The McPC TX/FX is an IEEE 802.3 single-conversion PC media converter card that converts: • 10Base-T twisted pair and 10Base-FL

2 PCI Version Installing the McPC 10/100 (PCI Version) Offering plug-and-play operation, the McPC 10/100 comes ready to install, utilizing power from

3 The table below shows the DIP Switch settings for McPC 10/100: Feature Switch # Function Default LFD 5 Link Fault Detection (Available in For

4 Modes of Operation (PCI Version) The McPC 10/100 features three modes of operation: Auto Negotiation mode (AN), Force-10 mode and Force-100 mode. C

5 There is no Auto Negotiation in either of the Force modes. Auto Negotiation (PCI Version) When connecting two McPC 10/100s between two end stations

6 When the McPC 10/100 is in one of the Force modes, enable LFD by setting 5 to the ON position. Disable LFD by resetting 5 to its default, OFF, posi