Imc-networks Management Module SNMP Manuel d'utilisateur télécharger pdf (Page 7)

1. Open a session in iConfig with a device you want to administer.

2. Choose the Administration tab.

3. Click the Save PROM File button.

4. The Save as PROM dialog box appears.

5. Choose a folder and then select the filename you wish to save.

NOTE

.BIN is the default extension.

6. Click the Save button to save, the file is saved.

7. Add entries to the Notes box, if desired; then click OK. If you do not

wish to enter Notes, click Close.

8. Click OK to close Succeeded dialog box. (Prom Save was successful.)

If the Management Module is removed with the SNMP Write Lock switch set

to NORMAL, all module revert to their hardware settings by default; for any

module with on-board logic, refer to its manual for details. Hardware

settings should be configured to match those made via SNMP. Always

reconfigure application modules when moving them from one chassis’ slot to

another.

Using the SNMP Write Lock Switch

1. Ensure the SNMP Write Lock switch is set to NORMAL.

2. After configuring all application module settings via SNMP, use the

iConfig application to make a backup copy of the SNMP management

board’s firmware.

3. If the SNMP Management Module needs to be replaced, set the SNMP

Write Lock switch to LOCKED.

4. Remove the old SNMP module and replace with another SNMP

module.

5. Connect to this SNMP module via iView² and then launch iConfig.

Select the Administration tab and click on List Tasks. Highlight Flashsav

and then click on the Terminate button.

6. Update the new board with the firmware backup made in Step 2.

7. Reboot the SNMP Management Module with the reboot command to

enable changes.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Pas de commentaire

Imc-networks Management Module SNMP Manuel d'utilisateur Page 7