IMC Networks iMcV-DS3/E3-LineTerm Manuel d'instructions télécharger pdf (Page 11)

Remote Management (DIP Switch S1, Position 10)

This switch enables or disables the Remote Management mode. Enabling Remote

Management on the Remote module allows all SNMP configurable features for the

Remote modules to be configured from the Host module.

NOTE

The Remote Management feature must be enabled on the Remote module. The Remote

module cannot be managed by the management chassis it is located in. The local

management can read the card settings but cannot make changes to them.

By default this feature is

Disabled

. The module acts as a HOST device in this default

setting.

This feature can be selected only by setting the DIP Switches manually.

Loopback Testing

The iMcV-DS3/E3/STS-LineTerm includes two loopback test modes: Coax Loopback

and Fiber Loopback.

The following illustrations show the path that a signal takes in each of the loopback

test modes.

Each loopback performs the following:

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

IMC Networks iMcV-DS3/E3-LineTerm Manuel d'instructions Page 11