IMC Networks IE-MiniFiberLinX-II w/ TELCO Power Manuel d'instructions télécharger pdf (Page 7)

LED Operation

The IE-MiniFiberLinX-II features two diagnostic LEDs:

FX LNK/ACT This LED is on when a FX Link exists and blinks when data passes

through the fiber connection.

TX LNK/ACT This LED is on when a TX Link exists and blinks when data passes

through the twisted-pair connection.

Powering Options

The IE-MiniFiberLinX-II powering options include AC and DC power as well as Power

over Ethernet, functioning as a PD compliant with 802.3af. The DC Terminal block

allows you to daisy-chain one IE-MiniFiberLinX-II to another. To use the DC terminal

block, connect to any one positive and any one negative terminal from a power

source. The illustration shows the wiring configurations for the DC terminal block (12

to 48 VDC).

Non-Telco Version

Telco Version

NOTE

For Telco Only: It does not matter which terminal is referenced (connected to) earth-

ground. For example, when using a -48 VDC supply in which the positive rail is

connected to earth-ground, simply connect this side to a terminal block “+” terminal

and the -48 VDC side to the negative terminals.

+5 to 24 VDC

12 to 48 VDC 7 to 50 VDC

+5 to 24 VDC

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Pas de commentaire

IMC Networks IE-MiniFiberLinX-II w/ TELCO Power Manuel d'instructions Page 7